Just listen to a pod cast of Tom Kyte explaining what’s new in 11g database. Sounds intresting, but unfortunately it’s just the first part of it and the second one isn’t published till yet! But you should check it out!
How would you repair the cable of a multimeter which is broken at the inner part of the grip? Well, a Friend of myself is doing it this way: Take the bigges rubber mallet you can find, smash the grip of the cable to get out the pin and dismantle the the calbe. Then take a soldering iron and tin-solder and try to fix the cable on the pin. After a couple of attempts you made it, then put back the pin into the grip and see, that the grip doesn’t hold anymore. So what you do to finish the repair? You take the soldering iron and move it around the pin on the plastic and – surprise – it’s repaired. And the worst case repair, if you wouldn’t get the cable onto the pin: You put as many tin-solder on it as possible and cut of the rest to get the pin back to the grip.
Well, it isn’t the smartest solution, BUT it works! 😀
After my predecessor destroid the second monitor of my workplace, it took me three months to get a new one (no one was available because of the inters in the office). Now finally I’ve a nice big Sun monitor with 21 inch where I could always see my monitoring tools of the database 🙂
Finally I did it. At this day I’ll also be a blogger. But now, because it’s late and tomorrow I have to throw a big… ok a middle party, I’ll go to bed. Good night world!